Amana 51432 InvectraTM Metal Laminate Trim Router Bit (1/2" Shank)

$211.03
Available: In stock
Amana 51432 Metal Laminate Flush Trim 1/2

Amana 51432 InvectraTM Metal Laminate Trim Router Bit (1/2" Shank)

The cutting edge of the Invectra router bit is engineered from an Amana-exclusive carbide grade designed specifically for cutting both metal laminates and wood-based substrate materials.

With Invectra™ router bits, kitchen fabricators, remodelers and construction workers can perform any kind of cut and trim job in aluminum laminates. Designed and tested for trimming all decorative aluminum laminates manufactured by Formica® (except Formica® #2178), Advanced Technology Inc. (ATI™), DecoMetal® and many others. 

Engineered from an Amana Tool® exclusive carbide grade designed specifically for cutting both aluminum laminates and wood-based substrate materials. Each bit is fitted with a steel bearing guide that enables users to trim laminate materials flush to the substrate, allowing you to perform any metal trim job to perfection!

Not for use on stainless steel.

Features:

These innovative new bits are specially designed and tested for trimming all decorative metal laminates and has been recommended by Formica, for use in all DecoMetal material (exluding #2178) & Advanced Technology Inc. (ATI) Both metal laminate manufacturers have recommended their use to all approved fabricators Exclusive micro-grain carbide delivers the highest quality of cut, maximum cutting efficiency and extended tool life To ensure the best cutting results, each bit is fitted with a steel bearing guide that enables users to trim laminate materials flush to the stubstrate 3-1/4" length 1/2" cutting diameter 1/2" shank

Write Your Own Review
You're reviewing:Amana 51432 InvectraTM Metal Laminate Trim Router Bit (1/2" Shank)
Your Rating
Customer care :800 852-1102
323 268 1347
copyright©2018. All Right Reserved.